SLIDING CLEATS:
A neat cost effective solution to fitting and positioning a mid ship spring cleat where genoa tracks are in the way or access to under the side deck is restricted. Simply remove a track end stop, slide on the cleat and lock in the desired position. When not in use slide to one end of the track or leave off one track end permanently to enable removal of cleat.

Alternatively, fitting a short length of track in the desired position enables cleats to be fitted or removed in seconds reducing deck clutter and eliminating rope snags. Designed to fit standard 25mm and 32mm "T" tracks, they are available in four sizes.

25mm cleats have an extruded aluminium base with a moulded nylon cleat and screw lock. 32 mm cleats have an extruded aluminium base with a cast aluminium cleat and plunger type lock.

CLAMP ON CLEATS:
Exclusive to Barton this unique design allows the base assembly to open and fit over existing "T" tracks. The clamp then screws firmly into place allowing this spring cleat to be fitted securely in any position on a genoa track in seconds.

Manufactured from high quality stainless steel with a cast aluminium cleat and available in two sizes.

CLAMP ON CLEATS FEATURES:

• Attachable / Detachable
• Fitted and removed in seconds
• Leaves decks clear when not in use
• Position where required on existing genoa tracks
• Available in 2 sizes - 25mm and 32mm

NOTE: Clamp on cleats will only operate correctly and safely on "T" tracks.

SHROUD CLEATS:
This handy fitting simply clamps onto a wire without causing damage. Ideal for use for flag halyards and can be fitted in seconds. Moulded in hard plastic it is supplied complete with backing plate and fastenings.

STANCHION CLEAT:
A neat fitting designed to fit over stanchions or pulpit / pushpit rails. Fits in seconds and will not damage tube.